AEBI Meyer Base Line 240 Series, Original Owner'S Manual

Page: 15 / 36

15 15
Controller will only be activated while ignition switch is at ON position. If the unit is wired into a keyed power source. There will be one inline fuse located at the incoming
power wire harness. This will be a 20A automotive ATO fuse. This 20A fuse protects the spreader motor and/or vibrate motor from over current conditions. In the event that
the fuse has opened circuited, replacement of the fuse will be required in order to restore the operation. Fuse replacement is facilitated with a pair of needle nosed pliers. The
controller also has overload protection built into the circuit board. If an overload occurs the green LED above the I/O button will turn red and will begin to fl ash. To reset, turn
off controller and clear obstruction from spreader then turn controller back on.
The controller will provide the spreader motor with multiple speed options per following:
ON/OFF Depress the button once to enable the spreader motor operation. Spreader motor will automatically be activated with 5 full power Blasts
and then stop. The GREEN LED located above this switch will illuminate.
ON/OFF Depress the button a second time and the spreader motor operation will stop. The GREEN LED located above this switch will stop illuminating.
FASTER Once spreader is activated, by depressing the FASTER button momentarily for the fi rst time, the motor will start rotating at the lowest speed.
If the button is depressed again, motor will gain speed. Faster button can be depressed momentarily or held depressed to achieve maximum
speed. There are ten programmed speed settings that increase the speed in increments of 10%. The GREEN LED located above the I/O
button will fl ash in unison with the speed setting. The fastest speed causes the GREEN LED to fl ash at a rate of 10 fl ashes every second.
SLOWER By depressing the SLOWER button, the motor speed will decrease. There are ten programmed speed settings that decrease the speed in
increments of 10%. SLOWER button can be depressed momentarily or held depressed to slow down the motor until it comes to a halt.
The LED located in the centerwill provide a number for the speed setting. 1 is slowest and 10 is fastest.
VIBRATE
(On/Off) Depress the button once to enable the vibrate motor operation. The GREEN LED located above this switch will illuminate at full intensity.
VIBRATE
(On/Off) Depress the button a second time and the vibrate motor operation will stop. The GREEN LED located above this switch will stop
illuminating.
Base Line
Controller
SAFETY PRECAUTIONS SAFETY PRECAUTIONS
SEE PAGES 6-7 FOR DEFINITIONS
1/2/3/4 5/6/7/8/13/15/16/17