Installation
LV3620
2–6
2.5 Making connections
The input and output terminals are located on the rear panel of the amplifier,
and both sets of output binding posts are internally connected in parallel.
Use care when making connections, selecting signal sources, and controlling
the output level. AE Techron is not liable for damage that results from faulty
connections or overdriving components in your system.
2.5.1 Output connection
Connect the load across the red and black binding posts.
Note
: Both sets of output binding posts for each channel are inter-
nally connected in parallel (red is connected to red and black to
black).
Consider the power-handling capacity of your load before connecting it to the
amplifier. AE Techron is not liable for damage incurred at any time due to any
load being overpowered. The use of load protection fuses is highly
recommended (see Section 2.5.3).
Never connect the output to a power supply output, battery, or power main.
Use load cables with sufficient gauge (thickness) for the length used. The
resistance introduced by inadequate load cables will reduce the output power.
The risk of potentially lethal
ELECTRIC
SHOCK exists when making connections.
Always shut off the amplifier and wait at
least 10 seconds before changing any
connections.
DANGER
PUSH TO RESET
REG. U.S. PAT. OFF.
4,330,809
4,611,180
4,788,452
100 VAC / 7.5 A / 50-60 Hz
120 VAC / 7.5 A / 50-60 Hz
230 VAC / 7.5 A / 50-60 Hz
CAUTION: TURN OFF AMPLIFIER
BEFORE CHANGING THIS SWITCH!
STEREO
BRIDGED
MONO
PARALLEL
MONO
(–)
(+)
CH-2
CH-1
BALANCED INPUTS
+ = NON-INVERTING
– = INVERTING
(–)
(+)
P.I.P. - BB
CH-2
CH-1
GROUND LIFT
Z
UNBALANCED
INPUT WIRING
+
CHASSIS
GROUND
LIFT
TIP
SLEEVE
GND
BALANCED
INPUT WIRING
+
–
TIP
RING
SLEEVE
GND
I N P U T
SIGNAL
GROUND
C
H
2
IMPORTANT:
CLASS 1 OUTPUT WIRING
REQUIRED.
O U T P U T
BRIDGED MONO WIRING
TURN AMP OFF.
SET STEREO–MONO SWITCH
TO BRIDGED MONO.
OUTPUT ACROSS RED
TERMINALS ONLY.
(CH-1 IS POSITIVE.)
1
2
3
C
H
1
(+)
(–)
(+)
(–)
INPUT SOURCE
Shields
(–)
(+)
LOAD
(–)
(+)
LOAD
(–)
(+)
LOAD
(–)
(+)
LOAD
CH-2 LOADS
CH-1 LOADS
Illustration 2–5 Connections for dual-channel operation
