advidia A-200, Installation Manual, Page: 26 / 46

A-200 Installation Manual
20
3.2.2 Corner Mounting
Before you start:
The corner mount is applicable to indoor/outdoor 90° solid construction corners. The following are
the mandatory requirements for corner mounting:

The wall must be thick enough to install the expansion screws.

The wall must be strong enough to withstand more than 8 times the weight of the dome
and its accessories.
Steps:
1. Install the corner adapter.
Steps:
(1) Drill four holes in the corner according to the screw holes of the corner adapter, and then
insert M8 expansion screws (not supplied) into the holes.
(2) Pull the power line, video cable and control line through the center hole of the corner
adapter.
(3) Attach the corner adapter to the corner by aligning the 4 screw holes of the corner adapter
with expansion screws on the corner.
(4) Secure the corner adapter to the corner with the nuts and washers to tighten the four
expansion screws.
Figure 3-8 Pull the Power Line
Note : Make sure that the cables have enough length. For outdoor applications, please apply sealant
around the center hole to waterproof it.
2.
Attach the gasket then the wall mount to the corner adapter.
3. Secure the wall mount to the corner adapter with 4 hex screws and spring washers.
Note: When tightening the screw, it is better to compress the spring washer tightly first and then
rotate it a half-turn to allow for water-proof without damaging the threads.
Nuts and Washers