PLANAR
Edition 1
March 2016
Page. 11 of 29
4
Heater Dismounting and Disassembly.
Replacement or checking of the heater components requires its partial disassembly.
Partial disassembly of the mounted heater is allowed, if there is an access to the
dismounted components.
4.1. –Dismounting and Disassembly of PLANAR-2D
- remove the heater from VEH;
- remove the upper and lower casings;
Casing should be removed as follows:
a) Remove clips. To remove clip, use screwdriver (with a thin tip) to pry the clip
out and slide it left or right for full release (Fig. 1);
b) Remove grids rotating them in either direction;
c) Removeupper and lower casing shells.
Fig.1- Removal of clips from casing.
- disconnect the contacts from the control unit (1 – glow plug contacts, 2 – sensor
contacts, 3 – AB contacts);
Fig.2–Heater.
