3.
2.
4.
1.
5.
6.
INSTALLING THE UNIT IN A VEHICLE
Tools Required
Installing the Snap On Covers
The ADVDLX10 A is supplied with black, shale and pewter plastics to allow a custom installation. Choose the desired cover and install as follows.
1. #2 Phillips Screwdriver
2. #1 Phillips Screwdriver
3. Utility or Razor Knife
4. Wire Strippers
5. Upholstery hook tool (for removal of panels as necessary)
6. Electrical Tape
7. Masking Tape
8. Multimeter to verify 12 volt DC and continuity (Do not use a test
light or logic probe)
9. Marker pen – to mark headliner, to mark trim ring if used
10. Misc. Electrical Connectors (to connect to vehicle power source,
requirements will vary from vehicle to vehicle)
11. DVD Movie (to verify system operation after installation)
Preparation
Place the unit on a soft surface to avoid damaging the plastic.
5
Housing
Snap On Cover
(Shroud)
1 Black, 1 Pewter, and
1 Shale
Snap On Cover
(Screen Back Cabinet)
1 Black, 1 Pewter, and
1 Shale
Pry Tool
Screw Cap
(L & R)
2 Black, 2 Pewter,
and 2 Shale
USB Cover
