UNO-2483G/2473G Quick Start Guide
8
2.3
LAN: Ethernet Connector
UNO-2483G/2473G are equipped with four/two Gigabit LAN controllers.
For the UNO-2483G and UNO-2473G-E3AE:
The controller chip used is an Intel® i210-IT GbE Ethernet controller that is fully
compliant with 802.1Qac, IEEE1588/802.1AS, 802.3az
The controller chip used is an Intel® i218-LM GbE Ethernet controller that is
fully compliant with Intel® AMT, IEEE1588/802.1AS, 802.3az
For the UNO-2473G-J3AE
The controller chip used is an Intel® i210-IT GbE Ethernet controller that is fully
compliant with 802.1Qac, IEEE1588/802.1AS, 802.3az
The Ethernet port is a standard RJ-45 jack, and LED indicators are on the front
to show its Link (Green LED) and Active (Yellow LED) status.
2.4
Power Connector
The UNO-2483G/UNO-2473G comes with a Phoenix connector that carries external
power input as below, and features reversed wiring protection so it will not cause any
damage to the system due to reversed wiring of ground line and power line. Please
refer to Appendix A.5.
UNO-2483G and UNO-2473G-E3AE: 24VDC+/-20%
UNO-2473G-J3AE: 12VDC+/-20% and 24VDC+/-20%(e.g +12V @1.16A)
2.5
USB Connector
The USB interface supports Plug and Play, which enables you to connect or discon
-
nect a device whenever you want, without turning off the computer. UNO-2483G/
UNO-2473G provides four connector USB interface, which gives complete Plug &
Play and hot swapping for up to 127 external devices. Two of the four connectors on
UNO-2483G and one of the four connector on UNO-2473G are USB 3.0 standard.
The USB interface complies with USB EHCI, Rev. 2.0 compliant. The USB interface
can be disabled in the system BIOS setup. Please refer to Appendix A.6 for its pin
assignments.
2.6
HDMI Display Connector
The UNO-2483G/UNO-2473G provides a HDMI controller for a high resolution inter
-
face. UNO-2483G/UNO-2473G supports up to full HD resolution for two independent
displays. DisplayPort is also available on a per-project basis.
Note!
UNO-2483G with i218 LAN chip can support AMT9.0.