Advantech TREK-688, User Manual

Page: 21 / 67

TREK-688 User Manual 1
Chapte
r 2
System
Setup
Warning!
Do not remove the HDD/SSD tray when system running.
Power must be switched off in advance. Take care in
order to avoid injury or damage to the equipment.
2.2 Installation Procedures
2.2.1 Connecting the Power Cord
Connect the three pin waterproof power cord to the DC inlet of the In-Vehicle Com-
puting Box. On the open-wire end, one pin is reserved for positive voltage and is
marked, "+"; one pin is reserved for ground and is marked, "-"; and, one pin is
reserved for the ignition signal with an “ignition” mark.
Note!
Ignition on/off setting: The TREK-688 supports an ignition on/off function
so that you can power on/off the TREK-688 via the ignition signal/volt-
age and connect the TREK-688 vehicle ignition switch.
Table 2.1: Pin Definition of Power Cord
Pin Definition Color
1 - Black
2 + Red
3 Ignition Orange
2.2.2 Power Connector