TPC-XX81WP
User Manual
vii
Safety Instructions
1.
Read these safety instructions carefully.
2.
Keep this User Manual for later reference.
3.
Disconnect this equipment from any AC outlet before cleaning. Use
a damp cloth. Do not use liquid or spray detergents for cleaning.
4.
For plug-in equipment, the power outlet socket must be located near the
equip- ment and must be easily accessible.
5.
Keep this equipment away from humidity.
6.
Put this equipment on a reliable surface during installation. Dropping it or
letting it fall may cause damage.
7.
The openings on the enclosure are for air convection. Protect the
equipment from overheating. DO NOT COVER THE OPENINGS.
8.
Make sure the voltage of the power source is correct before
connecting the equipment to the power outlet.
9.
Position the power cord so that people cannot step on it. Do not place
anything over the power cord.
10.
All cautions and warnings on the equipment should be noted.
11.
If the equipment is not used for a long time, disconnect it from the power
source to avoid damage by transient overvoltage.
12.
Never pour any liquid into an opening. This may cause fire or electrical shock.
13.
Never open the equipment. For safety reasons, the equipment
should be opened only by qualified service personnel.
14.
If one of the following situations arises, get the equipment checked by
service personnel:
The power cord or plug is damaged.
Liquid has penetrated into the equipment.
The equipment has been exposed to moisture.
The equipment does not work well, or you cannot get it to work
according to the user's manual.
The equipment has been dropped and damaged.
The equipment has obvious signs of breakage.
15.
DO NOT LEAVE THIS EQUIPMENT IN AN ENVIRONMENT WHERE
THE STORAGE TEMPERATURE MAY GO BELOW -20° C (-4° F) OR
ABOVE 60° C (140° F). THIS COULD DAMAGE THE EQUIPMENT.
THE EQUIPMENT SHOULD BE IN A CONTROLLED ENVIRONMENT.
16.
CAUTION: DANGER OF EXPLOSION IF BATTERY IS
INCORRECTLY REPLACED. REPLACE ONLY WITH THE SAME OR
EQUIVALENT TYPE RECOMMENDED BY THE MANUFACTURER,
DISCARD USED BATTERIES ACCORDING TO THE
MANUFACTURER'S INSTRUCTIONS.
17.
Caution! ATTENTION: Danger d'explosion si la batterie est mal
REMPLACE. REMPLACER UNIQUEMENT PAR LE MEME TYPE
OU EQUIVALENT RECOMMANDÉ PAR LE FABRICANT, jeter les
piles usagées SELON LES INSTRUCTIONS DU FABRICANT.
18.
This equipment is suitable for use in Class I, Division 2, Groups A, B,
C and D or non-hazardous locations only.
19.
WARNING - EXPLOSION HAZARD. DO NOT DISCONNECT WHILE
THE CIRCUIT IS LIVE OR UNLESS THE AREA IS FREE OF
IGNITIBLE CONCENTRATIONS.
20.
WARNING
– FOR 3.5 MM JACK INSTALLTION, THE JACK MUST
BE INSTALLED PER THE AUDIO-IN CABLE LOCK PROCEDURE
BEFORE USE.
v
Summary of Contents for TPC-1881WP Series
