Advantech SmartStart Start Manual Download Page 3

Page: 3 / 4

START GUIDE

3. Power

The router requires an external DC power supply. The DC voltage required is between

+9 to +36 V DC. The router has built-in protection against reverse polarity without signaling.
Connect the power supply cable to the

PWR

connector on the front panel of the router (see

figure below).

4. Ethernet

An Ethernet cable may be connected to the

ETH

connector (designated as

ETH0

in some

versions of this router) on the front panel (see figure above). By default, the Ethernet port is
configured as follows:

Connector

Purpose

Default Setting

ETH

LAN port (default)

Connect your laptop or PC to this port to
get a local web-server for device configu-
ration and diagnostics.

DHCP Server

IP Address: 192.168.1.1
NetMask: 255.255.255.0

QSG issued in CZ, May 10, 2016

Summary of Contents for SmartStart

Page 1: ...re and high temperature It is recommended that you do not use the router at petrol filling stations We recommend observing local restrictions concerning the use of radio based devices while working wi...

Page 2: ...by screwing on the ANT connector see the figure below A second diversity antenna can also be connected to the DIV connector to improve performance 2 SIM card The SIM card readers for 3 V and 1 8 V SIM...

Page 3: ...r see figure below 4 Ethernet An Ethernet cable may be connected to the ETH connector designated as ETH0 in some versions of this router on the front panel see figure above By default the Ethernet por...

Page 4: ...nfiguration manual for more information When the PWR LED starts blinking it is possible to restore the default configuration of the router by pressing the RST button on the rear panel After pressing t...