SKY-6100 Startup Manual
/SKY-6100快速入门手册/SKY-6100快速入門手冊
5
Before inserting the gold finger into the connector, make
sure two grooves are located well into the nut on the chas-
sis as shown below.
插入外接卡金手指到高密度连接器之前，请确保集成盒上的
两个沟槽与机箱的定位点已经确实的如下图安装。
插入外接卡金手指到高密度連接器之前，請確保集成盒上的
兩個溝槽與機箱的定位點已經確實的如下圖安裝。
3. Left Riser Card Cage (LRF)
外接卡集成盒（左）
外接卡集成盒（左）
When installing LRF, align three grooves on the card cage
with the nut on the chassis to make sure the riser card
goldfinger is aligned to the high density connector on the
motherboard.
安装左边的外接卡集成盒时，对齐集成盒上的三个沟槽与机
箱边缘的定位点，以确保外接卡金手指与主板上的高密度连
接器有正确对准位置。
安裝左邊的外接卡集成盒時，對齊集成盒上的三個溝槽與機
箱邊緣的定位點，以確保外接卡金手指與主機板上的高密度
連接器有正確對準位置
Before inserting the goldfinger to the connector, make sure
three grooves are located well into the nut on the chassis as
below figure shown.
插入外接卡金手指到高密度连接器之前，请确保集成盒上的
三个沟槽与机箱的定位点已经确实的如下图安装。
插入外接卡金手指到高密度連接器之前，請確保集成盒上的
三個溝槽與機箱的定位點已經確實的如下圖安裝。
Slide Rail installation
1. Remove the chassis (inner) member.
Pull the slide open, then press the trigger down as
shown on the drawing, and pull the chassis (inner)
member out.
2. Mount the chassis (inner) member into the chassis.
You may opt for M4 or M5 pan head screw. The screw
head of either M4 or M5 can not exceed 2.0 mm.
Alternatively, you may mount the slide member to the
chassis through standoffs. Likewise, the head of stand-
off can not exceed 2.0 mm. Each side of chassis needs
to use 3 screws or standoffs for the slide attachment.
3. Attach the cabinet (outer) member to the rail.
Insert the stag into the upper and lower square holes
on EIA rail from the back of rail. Push the safety lock
forward to secure the bracket. It is important to check if
the safety lock is in the unlocked position before mount-
ing the brackets.
System Setup
/系统安装/系統安裝
System Setup
/系统安装/系統安裝
