3 PCI-7032 Startup Manual
JWDT1 + JOBS1: Watchdog Timer Output Selection
and HW Monitor Alarm
Closed Pins
Result
2-3*
Enable watchdog timer*
4-5*
Enable hardware monitor alarm*
* Default setting
ATXF1: AT/ATX mode selection
Closed Pins
Result
Short Short Pin 1,2
AT mode*
Connect to backplane with 1700002343
ATX mode
* Default setting
Jumpers and Connectors (Cont.)
BZ1: Buzzer Setting
Closed Pins
Result
3-4*
Enable buzzer*
1-2
Connect external speaker
* Default setting
The CD contains a driver installer program that will lead you
through the installation of various device drivers needed to
take full advantage of your CPU card.
Caution! The computer is provided with a battery-powered
real-time clock circuit. There is a danger of explo-
sion if the battery is incorrectly replaced. Replace
only with the same or equivalent type recommend-
ed by Advantech. Discard used batteries according
to the manufacturer’s instructions.
This device complies with the requirements in Part 15 of the FCC rules. Operation is subject to the following two conditions.
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
The locations of all connectors and jumpers:
Figure 1: Jumper and connector locations (G2 SKU)
COM12 SATA1
COM34
SATA2 DVI1 USB12 JCASE1 DIMMA1 ATX1
ATXF1
JFP1
SMBUS1
JOBS1+JWDT1
INV1
JLVDS2
JLVDS1
DIMMB1
J1900
JLVDS_VCON1
HDAUD1
LVDS1
CPUFAN1
GPIO1
VGA1
SWA1-4
JCOMS1
LAN1
LAN2
BZ1
USB7
KBMS1
KBMS2
USB34
USB56
LANLED1
Jumpers and Connectors (Cont.)
Software Installation
Board Layout
