MIC-3758DIO User Manual
10
Step 5:
Push the card into the slot gently by sliding the card along the
card guide until J1 meets the long needle on the backplane, then the
Blue
LED
on the front panel of the card will be lit.
Step 6:
Now push the card into the right place, and the
Blue LED
will
turn off.
Step 7:
After the
Blue LED
is off, push the handle to secure the card and
lock it into place.
.
2.2.2 Removing a CompactPCI Card
Step 1
: Push the handle down to unlock the card, and the CompactPCI
system will automatically uninstall the card configuration.
Step 2
: Once the system completes the configuration, the
Blue LED
will
be lit. Now you can slide the card out.
Note: If
your
card is correctly positioned and has
been slid all the way into the chassis, the han-
dle should match the rectangular holes. If not,
remove the card from the card guide and
repeat step 3 again. Do not try to install a card
by forcing it into the chassis.
Note:
Before the hot-swap function can be used, the
card must first be installed normally.
Note:
If your card is properly installed, you should
see the device name of your card listed on the
Device Manager tab.
Summary of Contents for MIC-3758DIO
