Advantech MIC-3365, Manual

Page: 31 / 115

2 0 MIC-3365 User's Manual
2.1 IDE Device (CN12)
The MIC-3365 provides two IDE (Integrated Device Electronics)
channels via the J3 connector to the rear transition board MIC-3302.
Four IDE drives can be connected to the MIC-3365 through the rear
transition board MIC-3302.
The MIC-3365F provides a mounting bracket to mount a 2.5" hard
disk drive on board. Users can connect this 2.5" hard disk drive to the
on-board 44-pin IDE connector (CN12).
Users can connect two IDE drives to each IDE channel. If two drives
are installed on one channel, remember to set one as the master and
the other one as the slave. You may do this by setting the jumpers on
the drives. Refer to the documentation that came with your drive for
more information. A jumper diagram usually appears on the top side
of a hard disk drive.
Warning: Plug the other end of the cable into the drive with pin
1 on the cable corresponding to pin 1 on the drive.
Improper connection will damage the drive.
Note: We don't recommend connection to the following
Seagate brand IDE HDD models: ST 31276A, ST
31720A, ST 32531A, ST 33240A or ST 34340A
2.2 Floppy Drive (CN11)
The MIC-3365 supports two floppy disk drives via the J3 connector
to the rear transition board MIC-3302. Users can connect up to two
floppy drives to the connector on the MIC-3302.
The MIC-3365F provides a mounting bracket to mount a slim-type
floppy disk drive on board. Users can connect this slim-type FDD to
the CN11 connector.