Advantech MIC-3358, User Manual

Page: 67 / 84

59 Chapter 4
SMBus Connector
Users can select IPMI source and application as below.
There are 3 options: MIC-3924B (Default), MIC-3924A and CMM.
LAN 1 Connector
The item allows you to choice LAN1 connective way. There are 3
options: Front (Default), 2.16 and Rear
LAN 2 Connector
The item allows you to choice LAN2 connective way. There are 2
options: 2.16 and Rear (Default)
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple
sector read/write. If your IDE hard drive supports block mode (most new
drives do), select Enabled for automatic detection of the optimal number
of block read/writes per sector the drive can support. The settings are:
Enabled (Default), Disabled.
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDD)
installed on the system board and you wish to use it. If you install add-on
FDC or the system has no floppy drive, select Disabled in this field. The
settings are: Enabled (Default) and Disabled.
Onboard Serial Port 1/Port 2
Select an address and corresponding interrupt for the first and second
serial ports. The Serial Port 1 settings are: 3F8/IRQ4 (Default), 2E8/
IRQ3, 3E8/IRQ4, 2F8/ IRQ3, Disabled, Auto.
Source connected CMM
PCF8584T MIC-3924B
Hardware Monitor 83782D MIC-3924A
BMC (PMC type) (Reserved) CMM (Reserved)