MIC-3056 User Manual -- Page 11
2.3.5 Installing a Slim-type Floppy Disk or Slim-type CD-ROM Drives (on
MIC-3960):
The MIC-3960 supports up to four IDE devices on the two IDE channels
including IDE CD-ROM drives. But user only can have up to three IDE
devices (including CompactFlash) due to its space limitation. To install an
IDE slim type CDROM drive with the MIC-3960 you'll need:
·
IDE CD-ROM drive
. Mounting bracket for slim type CDROM
. Several screws for bracket
.
The MIC-3960 does not supply a power cable to run a CD ROM drive or other
desktop style IDE device cause the power is provided via the connectors.
Steps for installing an IDE CD-ROM drive with the MIC-3960 are as follows:
1. Turn the power off to the card cage and remove the MIC-3960.
2. Mounting the IDE CD-ROM with bracket and screws on MIC-3960
3. Re-insert the MIC-3960 into the card cage.
4. Power up the card cage and the CD ROM.
2.3.6 Replacing the Hot-swap Fan and Air Filter
The MIC-3038 provides two hot-swap fans at both left and rear sides of the
MIC-3038. Please refer to Figure 2-1 and 2-2. Each fan can be individually replaced.
This can be done without turning off the system power or interrupting system
operation.
Follow these steps to replace a fan:
1. Unfasten the fan's holder.
2. Slide the fan's holder out.
3. Replace the old fan with a new one.
4. Slide the fan's holder in.
5. Fasten the new fan's holder.
