Start Guide
3. Power
The router requires an external DC power supply. The DC voltage required is between
+9 and +48 V DC. The router has built-in protection against reverse polarity without signaling.
Connect the power supply cable to the PWR connector on the left panel of the router (see the
figure below) and tighten the locking screws.
4. Ethernet
For an initial configuration made in a web browser, connect a PC by an Ethernet cable to
the default LAN interface, use the
ETH0
port; see the figure above. By default, this interface
has the following configuration:
Connector
Purpose
Default Setting
ETH0
LAN port (default)
Connect your PC to this port to get the
router web interface.
DHCP Server
IP Address: 192.168.1.1
NetMask: 255.255.255.0
QSG-0011-EN, October 5, 2022
5
Released in the Czech Republic
