EKI-7657C _Manual_ed1
42
IP Configuration
User can configure the IP Settings and DHCP client function here.
•
DHCP Client
: Enable or disable the DHCP client function. When DHCP client function is enabled, the
industrial switch will be assigned an IP address from the network DHCP server. The default IP address
will be replaced by the assigned IP address on DHCP server. After user click
Apply
, a popup dialog
shows up. It is to inform the user that when the DHCP client is enabled, the current IP will lose and
user should find the new IP on the DHCP server.
•
IP Address
: Assign the IP address that the network is using. If DHCP client function is enabled, and
then the user doesn’t need to assign the IP address. And, the network DHCP server will assign the IP
address displaying in this column for the industrial switch. The default IP is 192.168.16.1.
•
Subnet Mask
: Assign the subnet mask to the IP address. If DHCP client function is enabled, and then
the user does not need to assign the subnet mask.
•
Gateway
: Assign the network gateway for the industrial switch. The default gateway is 192.168.16.254.
•
DNS1
: The abbreviation of Domain Name Server—an Internet service that translate domain name into
IP addresses. Domain name are alphabetic which are easy to be remembered. Because the Internet is
based on IP address; every time you use a domain name, therefore, a DNS service must translate the
name into the corresponding IP address. For example, the domain name
www.net.com
might
translate to 192.168.1.1
•
DNS2
: The backup for DNS1. When DNS1 cannot function, DNS2 will then replace DNS1 immediately.
•
And then, click
Apply
Figure 3.9: IP Configuration
Summary of Contents for EKI-7657C
