Advantech EKI-7657C, User Manual

Page: 37 / 110

27 Chapter3
After you have logged in to the system, you will see a command prompt. To enter CLI management interface,
type in the “
enable
” command.
Figure 3.4: Command Line Interface
The following table lists the CLI commands and description.
3.1.1 Commands Level
Table 3.1: Command Level
Modes Access Method Prompt Exit Method About This Model
User EXEC
Begin a session with
your switch.
switch>
Enter
logout
or
quit
. The user commands available
at the user level are a subset
of those available at the
privileged level.
Use this mode to
•
Perform basic tests.
•
Display system information.
Privileged
EXEC
Enter the
enable
command while in
user EXEC mode.
switch#
Enter
disable
to exit. The privileged command is the
advanced mode
Use this mode to
•
Display advanced function
status
•
Save configuration
Global
configuration
Enter the
configure
command while in
privileged EXEC
mode.
switch(config)#
To exit to privileged
EXEC mode, enter
exit
or
end
Use this mode to configure the
parameters that are going to
be applied to your switch
VLAN database
Enter the
vlan
database
command
while in privileged
EXEC mode.
switch(vlan)#
To exit to user EXEC
mode, enter
exit
.
Use this mode to configure
VLAN-specific parameters.
Interface
configuration
Enter the
interface
command (with a
specific interface)
while in global
configuration mode
switch(config-if)#
To exit to global
configuration mode,
enter
exit
.
To exist to privileged
EXEC mode, enter
exit
or
end.
Use this mode to configure the
parameters for the switch and
Ethernet ports.