Advantech eki-7656c, User Manual, Page: 42 / 114

form of this command to disable
the port.
show interface configuration
I
show interface configuration status switch(config)#
interface fastEthernet 2
switch(config-if)#
show interface configuration
show interface status
I
show interface actual status switch(config)#
interface fastEthernet 2
switch(config-if)#
show interface status
show interface accounting
I
show interface statistic counter switch(config)#
interface fastEthernet 2
switch(config-if)#
show interface accounting
no accounting
I
Clear interface accounting
information switch(config)#
interface fastEthernet 2
switch(config-if)#
no accounting
3.2.5 Trunk Commands Set
Table 3.5: Trunk Commands Set
Command Level Description Example
aggregator priority
[1~65535]
G
Set port group system priority switch(config)#
aggregator priority 22
aggregator activityport
[ Group ID ]
[Port Numbers]
G
Set activity port switch(config)#
aggregator activityport 2
aggregator group
[GroupID] [Port-list]
lacp
workp
[Workport]
G
Assign a trunk group with LACP
active.
[GroupID] :1~3
[Port-list]:Member port list, This
parameter could be a port
range(ex.1-4) or a port list separate
by a comma(ex.2, 3, 6)
[Workport]: The amount of work
ports, this value could not be less
than zero or be large than the
amount of member ports. switch(config)#
aggregator group 1 1-4 lacp workp
2
or
switch(config)#
aggregator group 2 1,4,3 lacp
workp 3
aggregator group
[GroupID] [Port-list]
nolacp
G
Assign a static trunk group.
[GroupID] :1~3
[Port-list]:Member port list, This
parameter could be a port
range(ex.1-4) or a port list separate
by a comma(ex.2, 3, 6) switch(config)#
aggregator group 1 2-4 nolacp
or
switch(config)#
aggregator group 1 3,1,2 nolacp
show aggregator
P
Show the information of trunk group switch#
show aggregator 1
or
switch#
show aggregator 2
or
switch#
show aggregator 3
no aggregator lacp
[GroupID]
G
Disable the LACP function of trunk
group switch(config)#
no aggreator lacp 1
no aggregator group
[GroupID]
G
Remove a trunk group switch(config)#
no aggreator group 2
3.2.6 VLAN Commands Set
Table 3.6: VLAN Commands Set
Command Level Description Example
vlan database P
Enter VLAN configure mode switch#
vlan database
Vlanmode V
To set switch VLAN mode. switch(vlan)#
vlanmode portbase
EKI-7656C_7656CI_Manual 32