Advantech ASMB-584, User Manual

Page: 19 / 110

7 ASMB-584 User Manual
Chapter 1
H
ardware
C
onfiguration
1.6 ASMB-584 Block Diagram
Figure 1.3 ASMB-584 Block Diagram
1.7 Safety Precautions
Block Diagram
Intel LGA 1150
Haswell WS
Processors
Channel A
Intel C226 PCH
600MB/s
USB 2.0
HD Audio
DMI
(ECC) DDR3 1066/1333/1600
(ECC) DDR3 1066/1333/1600
Channel B
USB 3.0
(ECC) DDR3 1066/1333/1600
(ECC) DDR3 1066/1333/1600
One PCIe x16 slot
One PCIe x16 slot
Level Shifter DVI
PCIe x4
RGB
PCIe x 1
Gen 1.0
PCIe Gen 3.0 x8
PCIe Gen3.0 x8
Display Port
Display Port
One PCIe x 4 slot
4 USB 3.0
USB 2.0
PCIe x 1
Gen 2.0
ITE 8892F
PCIe x 1
Gen 1.0
G-LAN1:
Intel I217-LM
(PHY)
BMC
Connector
(Optional for IPMI)
PCIe x 1
Gen 2.0
G-LAN2:
Intel I210-AT
1 PCI slots
Winbond 83782D
LPC Connector
VGA D-Sub
6 SATA Ports with
RAID 0,1,5,10
Audio Codec
Realtek ALC892
128 Mbit
BIOS Flash
Nuvoton
NCT6776
9 USB 2.0
DP
DP
DP
FDI
LPC Bus
SPI Bus
NC-SI
SM BUS
2 RS 232
1 LPT
8 bit GPIO
PS/2 KB, MS
Warning! Always completely disconnect the power cord from your chassis when-
ever you work with the hardware. Do not make connections while the
power is on. Sensitive electronic components can be damaged by sud-
den power surges. Only experienced electronics personnel should open
the PC chassis.
Caution! Always ground yourself to remove any static charge before touching the
motherboard. Modern electronic devices are very sensitive to static
electric discharges. As a safety precaution, use a grounding wrist strap
at all times. Place all electronic components on a static-dissipative sur-
face or in a static-shielded bag when they are not in the chassis.
Caution! The computer is provided with a battery-powered real-time clock circuit.
There is a danger of explosion if battery is incorrectly replaced. Replace
only with same or equivalent type recommended by the manufacturer.
Discard used batteries according to manufacturer’s instructions.
Caution! There is a danger of a new battery exploding if it is incorrectly installed.
Do not attempt to recharge, force open, or heat the battery. Replace the
battery only with the same or equivalent type recommended by the man-
ufacturer. Discard used batteries according to the manufacturer’s
instructions.