Advantech ARK-7060, User Manual

Page: 78 / 106

ARK-7060 User Manual 66
– Assert NMI on PERR
On PERR, generate an NMI and log an error. Note: This option is only active
if the Assert NMI on SERR option has [Enabled] selected.
– Expected BER
Set the expected Bit Error Rate for all speeds.
– Time Window (Gen1/2)
Set the error burst protection time window for Gen1 and Gen2 speeds. A
burst of errors within the window is counted as one.
– Time Window (Gen3/4)
Set the error burst protection time window for Gen3 and Gen4 speeds. A
burst of errors within the window is counted as one.
– Error Threshold (Gen1/2)
Set the error threshold for Gen1 and Gen2 speeds. An event is triggered
when the error count exceeds the threshold.
– Error Threshold (Gen3/4)
Set the error threshold for Gen3 and Gen4 speeds. An event is triggered
when the error count exceeds the threshold.
– Gen3/4 Re-Equalization
Enable or disable Gen3 and Gen4 re-equalization. Applies only when operat -
ing at Gen2 or Gen4 speeds. When an event is triggered, equalization is re-
run.
– Gen2 Link Degradation
Enable or disable Gen2 link degradation. Applies only when operating at
Gen2 speeds. When an event is triggered, 5GT/s and higher modes are dis -
abled.
– Gen3 Link Degradation
Enable or disable Gen3 link degradation. Applies only when operating at
Gen3 speeds. When an event is triggered, 8GT/s and higher modes are dis -
abled.
– Gen4 Link Degradation
Enable or disable Gen4 link degradation. Applies only when operating at
Gen4 speeds. When an event is triggered, 16GT/s and higher modes are dis -
abled.