AIMB-277 User Manual
8
1.8.2
CMOS Clear (JCMOS1)
The AIMB-277 motherboard contains a jumper that can erase CMOS data and reset
the system BIOS information. Normally this jumper should be set with pins 1-2
closed. If you want to reset the CMOS data, set CMOS1 to 2-3 closed for just a few
seconds, and then move the jumper back to 1-2 closed. This procedure will reset the
CMOS to its default setting.
1.8.3
Watchdog Timer Output and OBS Beep (JWDT1+JOBS1)
1.8.4
ATX/AT Mode Selection (PSON1)
Table 1.2: JCMOS1
Function
Jumper Settings
Keep CMOS data (Default)
Clear CMOS data
1-2 closed
1
2-3 closed
1
Table 1.3: Watchdog Timer Output and OBS Beep (JWDT1+JOBS1)
Function
Jumper Setting
Watchdog Timer Output (2-3) (Default)
OBS BEEP(4-5) (Default)
(2 and 3)+(4 and 5)
Watchdog Timer Disable (1-2)
OBS BEEP(4-5) (Default)
(1 and 2)+(4 and 5)
Table 1.4: ATX/AT Mode Selection (PSON1)
Function
Jumper Setting
ATX Mode (Default)
AT Mode
Summary of Contents for AIMB-277
