25
AIMB-225 User Manual
Chapter 2
C
onnecting
Peripherals
2.7.5
Power LED and keyboard lock connector (JFP3 / PWR_LED &
KEY LOCK)
(JFP3 / PWR_LED & KEY LOCK) is a 5-pin connector for the power on LED and Key
Lock function. Refer to Appendix B for detailed information on the pin assignments.
The Power LED cable should be connected to pin 1-3. The key lock button cable
should be connected to pin 4-5. There are 3 modes for the power supply connection.
The first is “ATX power mode”; the system turns on/off by a momentary power button.
The second is “AT Power Mode”; the system turns on/off via the power supply switch.
The third is another “AT Power Mode” which makes use of the front panel power
switch. The power LED status is indicated in the following table:
2.8
Line Out Connector (AUDIO1)
Table 2.2: ATX pwr supply LED status (No AT power support)
Power mode
LED
(ATX Power Mode)
(On/off by
momentary button)
LED
(AT power Mode)
(On/off by switching
power supply)
LED
(AT power Mode)
(On/off by front
panel switch)
PSON1
(on back plane)
jumper setting
pins 2-3 closed
pins 1-2 closed
Connect pins 1 & 2 to
panel switch via cable
System On
On
On
On
System Suspend
Fast flashes
Fast flashes
Fast flashes
System Off
Slow flashes
Off
Off
Line out
Summary of Contents for AIMB-225
