Advantech AIMB-221, User Manual

Page: 27 / 108

17 AIMB-221 User Manual
Chapter 2
C
onnecting
Peripherals
You can attach up to one IDE (Integrated Drive Electronics) drive to the AIMB-221's
built-in controller.
Wire number 1 on the cable is red or blue and the other wires are gray. Connect one
end to connector IDE1 on the motherboard. Make sure that the red/blue wire corre-
sponds to pin 1 on the connector (in the upper right hand corner).
Connect the hard drive to the other end of the cable. Wire 1 on the cable should also
connect to pin 1 on the hard drive connector, which is labeled on the drive circuit
board. Check the documentation that came with the drive for more information.
IDE1
pin.1 #IDE_RST pin.2 GND
pin.3 IDE_D7 pin.4 IDE_D8
pin.5 IDE_D6 pin.6 IDE_D9
pin.7 IDE_D5 pin.8 IDE_D10
pin.9 IDE_D4 pin.10 IDE_D11
pin.11 IDE_D3 pin.12 IDE_D12
pin.13 IDE_D2 pin.14 IDE_D13
pin.15 IDE_D1 pin.16 IDE_D14
pin.17 IDE_D0 pin.18 IDE_D15
pin.19 GND KEY
pin.21 IDE_DREQ pin.22 GND
pin.23 IDE_#DIOW pin.24 GND
pin.25 IDE_#DIOR pin.26 GND
pin.27 IDE_IORDY pin.28 GND
pin.29 IDE_#DACK pin.30 GND
pin.31 IDE_IRQ pin.32 NC
pin.33 IDE_DA1 pin.34 IDE_#P66DET
pin.35 IDE_DA0 pin.36 IDE_DA2
pin.37 IDE_#CS1 pin.38 IDE_#CS3
pin.39 IDE_#ACT pin.40 GND