2
Easy
Setup
Safety
Instructions
Power
On
Computer
1.
Charge the embedded battery of the computer:
Connect the Micro USB adaptor on the AIM-37AC
computer. (“H
＂
on the I/O Ports section.) Please
charge for at least one hour when you use this
computer for the first time.
2.
Push the Power button (“K” on the I/O Ports
section.) for 3 seconds to start the computer.
3.
While the computer is running, push the power
button for 1 second will enter sleep mode for
power saving. Push the power button again will
enable the backlight again.
Please read these safety instructions carefully and follow
these instructions for use. Repair of the device may only
be carried by trained service personnel. Advantech
recommends that a service contact be obtained with
Advantech service and that all repairs also be carried out
by them; otherwise the correct functioning of the device
may be compromised.
WARNING! Because of the danger of electrical shock,
never remove the cover of a device while it
is in operation or connected to a power
outlet.
Use a damp cloth to clean the equipment and do not
spray detergent on the surface. Disconnect the
equipment from any AC outlet before cleaning.
If one of the following situations arises, have the
equipment checked by service personnel:
• The AC power adapter is damaged.
• The equipment does not power up even after charging.
• The equipment has obvious signs of breakage.
CAUTION! Do not replace the battery yourself. Please
contact a qualified technician or your retailer.
There is a danger of explosion if battery is
incorrectly replaced. Replace only with same
or equivalent type recommended by the
manufacturer.
FCC Compliance Statement
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly approved by the party
