ACP-1320BP User Manual
8
2.4
Installing add-on cards
ACP-1320BP can accept one PCI/PCIe add-on card on the backplane. To install an
add-on card, also refer to Figure 2.2 and proceed as follows:
1.
Plug in the add-on card until the card’s gold fingers have been inserted in an
PCI/PCIe slot of the backplane completely.
2.
Make sure that the card bracket has been inserted properly and the other edge
of the card has been fixed in the guiding rail.
3.
Fasten the card at the top of the bracket with a screw.
2.5
Adding disk drives
ACP-1320BP comes with two easy-to-maintain SATA HDD trays; it also accepts one
slim type optical disk drive and one 3.5” HDD/FDD. To install any of these disk drives,
refer to Figures 2.3 ~ 2.6 and proceed as follows:
2.5.1
Installing a SATA HDD in the SATA HDD tray
ACP-1320BP accepts both SATA and SATA II HDD. It is not necessary to remove
ACP-1320BP’s cover when installing a SATA HDD in any of the SATA HDD trays.
Figure 2.3 Removing the front bezel of the drive bay
Summary of Contents for ACP-1320BP
