Advantage Controls 200 Series, Manual

Page: 20 / 24

20
G. Misc. Setpoints
SETPOINT DESCRIPTION RANGE DEFAULT
106 RO RELAY - When start signal is received 0-9999 sec. 5
delay before RO pump starts.
107 TANK FULL DELAY - Delay before the RO 0-99 sec. 5
shuts down due to a tank full condition.
108 TANK FULL RESTART - Delay before RO 0-9999 sec. 5
starts after a tank full condition clears.
109 TANK FULL OVERRIDE - Time system will 0-9 min. 5
run when tank full override is initiated.
110 TANK LOW DELAY - Delay before a tank low 0-99 sec. 5
signal is valid.
111 TANK LOW RESTART - Delay before system 0-99 min. 15
restarts after a tank low condition clears.
112 PRETREAT LOCKDOWN DELAY - When the 0-99 sec. 5
pretreat in put is active, the delay before the
RO shuts down.
113 DIVERT DELAY - Sets time divert will remain 0-99 sec. 5
active after a high conductivity condition has
cleared.
114 AUTO RESET - When a shutdown condition 0-99 sec. 5
occurs, delay before system automatically
resets. When set to 00, Auto Reset is disabled.
115 ALARM SILENCE - When the Alarm Silence 0-999 sec. 300
button is pressed, the alarm will resound after
this delay. If set to 000, the alarm will remain
silenced.
116 MAX HOURS - If the current hours exceed 0-99999 0
this value, an Op Hours Exceeded warning
is generated. If set to 00000, this warning is
disabled.
117 CURRENT HOURS - The current operating hours. 0-99999 0
118 LOG INTERVAL - Selects data logging interval. 0-99 hrs. 0
If set to 0, logging is disabled.
119 SWITCH SELECT 1 - Programs switch inputs 0-225 0
on main board as N.O. or N.C. Default is all
normally open.
120 UNIT NUMBER - Sets unit number to identify 0-99 1
unit logging data.
121 FLUSH TYPE - Selects the type of flush for 0-8 0
the RO unit. If set to 0, flush is disabled.