3.3
Assemble the Spacer
3.3.1
Install the Air Cylinder
Use the 13-mm wrench to
tighten to a hard stop.
3.3.2
Tighten the Setscrew
Apply a small amount of Loctite
242 to the air cylinder setscrew
and tighten with the 2 mm hex
driver until the setscrew is tight
against the air cylinder.
3.3.3
Assemble the Spacer
Parts
Locate the new lever and
shoulder bolt, and also the nylon
spacer, spacer screws, and
automatic shutoff spring that
were set aside.
3.3.4
Check the Lever Assembly
Install the lever, observing the orientation of the
lever and washers as shown:
The shutoff spring rests in the bore in the
lever.
There is one washer on the shutoff cylinder
below the lever.
Proper positioning is critical.
3.3.5
Attach the Spacer
Install the spacer screws (#1PH).
Note: For proper engagement of the spacer
screws, the spacer and jet body must be
squeezed firmly together to keep the shutoff
spring compressed.
VERIFY
THAT
THE
BORE IN
THE
LEVER
FACES
THE
SPRING.
3A6326A
Advanjet HV-2100 Jet Maintenance and Repair
Page 19 of 30
