9
D- P6-
4
.
SET TO DEFAULTS:
Spin down the
switch
to the page 6
Press the button
4
.
Press the button
1
&
2
at same time to set the
defaults.
OPERATION:
A. REMOTE TRANSMITTER OPERATION:
Transmitter Button
System Function
Remark
1
Lock Doors & Arm System / Button
1
-
Arm and Bypass The Zone 4.
Press twice within 3 seconds
-
Arm System and Hidden Alarm Function
Press within 3 seconds
Car Locator
Upon armed
(3-second)
Panic function
Press and Hold for 3 seconds.
+
Silent Arming / Disarming
Ignition in "off" position.
+
(2-second)
Active Anti Car-Jacking Mode
Ignition in "on" position press and
hold for 2 seconds
2
Unlock Doors & Disarm System / Button
2
-
Two Steps Door Unlock & Disarm System
Press twice within 3 seconds.
3
Trunk Release
(2-second)
Trunk Release (Channel 3)
Press and Hold for 2 seconds
-
Passive Arming By-pass
While the system Disarmed.
4
Turn Off The Remote Start / Button
4
.
-
Activate The Remote Start
Press twice within 3 seconds.
+
Channel # 4 Timer Output
+
Channel # 5 Timer Output
+
Channel # 6 Timer Output
II
Switching code For 2nd
Car Operation.
For regular remote transmitter
Button Function Selection
For Two way Remote transceiver
Confirm Button / Back to Main Page
For Two way Remote transceiver
Feature Selection
For Two way Remote transceiver
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions.
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received, including interference that may cause undesired operation.
Per FCC 15.21, you are cautioned that changes or modifications not expressly approved by the part responsible
for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Summary of Contents for TRX970
Page 1: ...1 TRX970 OPERATION MANUAL...
