Advanced AF-5000, Installation Manual

Page: 126 / 267

Version 16.10
AF-6600 AF-5000 Series Install Manual
126
If you are using our Advanced Control Module (ACM) the Elevator Trim, Aileron Trim, and Flap position will
be wired to the ACM and
NOT Wired to the SV-EMS-220.
DB-37 Connector (Engine Sensors)
Pin EMS 37-pin Harness Wire Color Sensor
1 Red Optional Aithre CO Detector input
2 Yellow or Unwired Optional Aithre Tank PSI Detector input
3 Black Ground
4 Violet/Blue Carb Temperature (Skyview Input #1)
5 Black Ground
6 White/Yellow Oil pressure
7 White/Brown Oil temperature
8 Brown Fuel pressure
9 Brown/Blue Flap Position
10 Brown/Yellow Elevator Trim
11 Orange Aileron Trim (dsub 9 Pin 2)
12 Yellow Rudder Trim / Coolant Temperature
(dsub 9 Pin 3)
13 Black Ground (dsub 9 Pin 5)
14 Yellow Fuel flow
15 Red +8V Fuel Flow & Amps Hall Transducer Power.
(*Must have SV-EMS Network Pin 7 jumper to Pin 5)
16 Black Ground
17 Black Ground
18 White/Red +5V Aux Out 300ma
19 White/Black Fuel Flow Input 2
20 Orange/Brown Tank 1 – Float Sensor Only
21 Orange/Blue Tank 2 – Float Sensor Only
22 Violet/Yellow Tank 3 or Capacitance Tank 1
23 Violet/Green Tank 4 or Capacitance Tank 2
24 Orange/Green Ammeter shunt +
25 Orange/Violet Ammeter shunt -
26 Green/Red Manifold Pressure
27 Open Turbo Inlet 1 Temp +
28 Open Turbo Inlet 1 Temp -
29 Yellow/Green Not Used (Skyview Alarm )
30 Black Signal Ground (dsub 9 Pin 5)
31 White/Orange Ammeter Hall Effect
32 White/Green Standard RPM LEFT
33 White/Blue Standard RPM Right
34 Blue Low Voltage RPM Left (<12 Volts)
35 Green Low Voltage RPM Right (<12Volts)
36 Blue or Unwired Turbo Inlet Temp 2 +
37 Green or Unwired Turbo Inlet Temp 2 -