ADTRAN TRACER 2xT1, User Manual

Page: 45 / 65

TRACER 2xT1 User’s Manual
61280003L2-1B
Section 3 Operation
34 Preliminary
Configuration Menu
This screen allows all system configurations to be performed.
The menu selections are described below.
T1A and T1B Framing allow each T1 to be configured for SF or ESF framing.
T1A and T1B Line Code allow each T1 to be configured for AMI or B8ZS.
T1A and T1B Line Buildout allow each T1 to be configured for the appropriate line buildout, based on
the distance to the T1 equipment.
W A R N I N G
It is possible for the spreading code to be changed remotely through the VT-100 interface from the
other end of the link. When this is performed, communications will be lost to the far end. The
spreading code will change to code “0” and communications will be lost as soon as this change is
made. If this happens, set the Spreading Code on the local unit to code “0.” The units should regain
communications as soon as the correct code is selected.
Set Chipping Code allows the chipping code to be selected. Each end of the link must be configured for
the same chipping code.
Set Tx Power allows the transmitter power to be adjusted.
Set Freq Plan manually allows the frequency plan to be set to A or B. One end of a link must be set to
A and the other set to B. This function is automatically set when the BBP is attached to the
corresponding RFC.
Reset All Statistics resets all the error counters.
Enable/Disable Password allows password protection to be enabled or disabled. The default setting is
Disabled.
Change Password allows the password to be set.
Figure 3-12. Configuration Menu
TRACER Configuration Menu
Site: Adtran
1) T1A Framing 14) Enable/Disable T1 B
2) T1A Line Code 15) Change TBOS Display Number
3) T1A Line Build Out 16) Enable/Disable Modem Control
4) T1B Framing 17) Hangup Modem
5) T1B Line Code
6) T1B Line Build Out
7) Set Chipping Code
8) Set TX Power
9) Set Freq Plan
10) Reset all statistics
11) Enable/Disable Password
12) Change Password
13) Change Site ID
===============================================================================
Press ‘m’ - Main menu: