3G CDMA NIM/Cellular Interface
Configuring the 3G CDMA NIM Using the GUI
61700801G1-29.1H
Copyright © 2010 ADTRAN, Inc.
7
•
Set the demand routing interface sequence number.
•
Configure a route to the Internet through the demand routing interface.
•
Configure network address translation (NAT) parameters.
In addition to the preceding configurations, custom profile setting can be configured for the 3G CDMA
NIM through the GUI. These profile settings can be used to utilize services that require private IP services,
such as Sprint’s DataLink services. To learn more about configuring custom profile settings for the 3G
CDMA NIM, refer to
Configuring Custom Profile Settings
on page 18
.
Subscribing to a Cellular Network
Before attempting to connect the 3G CDMA NIM to the cellular network, make sure you have subscribed
to an appropriate CDMA service plan with your wireless service provider. The electronic serial number
(ESN) might be needed for this process. The ESN can be obtained from the label on the 3G modem or by
using the
show interface cellular hardware
command. Refer to
Viewing Cellular Hardware Statistics
on
page 49
for more details.
Accessing the GUI
To begin configuring the 3G CDMA NIM and cellular interface through the GUI, follow these steps:
1. Follow the directions on the
3G CDMA NIM Quick Start Guide
shipped with the NIM to enable the base
product to access the GUI. Make sure that the Ethernet interface is configured and the
ip http server
has been enabled.
2. Open a new Web page in your Internet browser.
3. Enter your AOS product’s IP address in the Internet browser’s address field in the following form:
http://
<ip address>
.
For example:
http://65.162.109.202
Refer to the
AOS Command Reference Guide
on the CD shipped with the base unit or
online at
http://kb.adtran.com
(article number 2219) for more information about the
ip
http server
command.
