Chapter 2. Installation
61200.128L1-1
Dual DSU-DP User Manual
7
Attaching the Plug-On Board
Figure 2-2 is representative of the action required for
proper attachment of a plug-on board to the option
module. Perform the following steps to install the plug-
on board:
1.
Hold the plug-on board above the option module.
2.
Using a downward and right-to-left motion, slip the
plug-on board connector into the opening in the
option module back panel.
3.
Moving the plug-on board downward, secure the
connection of the header pins at the front of the
boards.
4.
Install two 4-40 screws at both front edges of the
option module.
5.
Install two 4-40 screws on each of the standoffs on
the rear of the plug-on module.
Figure 2-2
Attaching the Plug-On Board
The connection of the header pins between the option module
and the plug-on board must be visually verified. Severe
damage of the equipment can result from an improper
connection.
PORT X.2
PORT X.1
PORT X
.4
PORT X
.3
HOT
REPLAC
EABLE
DUAL DSU-D
P
PORT X.3
