ADTRAN 1200063L1, Manual

Page: 79 / 137

61200063L1-20 DSU III TDM User Manual 7-1
Chapter 7
Configuring DTE Options
DTE OPTIONS
The DTE O
PTIONS
menu is used to select the configuration parameters that
control the operation of the DTE interface ports of the DSU III TDM. After
selecting
DTE O
PTIONS
, specify the port to be configured. The DTE O
P
-
TIONS
menu is then displayed with the specified port shown in the upper
right corner. Port 1 is the default.
DTE Rate
This option sets the operating speed of the DTE interfaces. All four ports
support several different DTE rates; however, the combined total for all
four ports cannot exceed the maximum bandwidth. The maximum band-
width for a loop rate of 56 kbps is 52.8 kbps, and 60.8 kbps for a loop rate
of 64 kbps. If the maximum bandwidth is exceeded, the message
M
AX
B
ANDWIDTH
E
XCEEDED
is displayed. The factory default setting is DTE
9.6K . DTE rate options 7 through E are available only for synchronous da-
ta. See the appendix Configuration Profiles on page B-1 for more informa-
tion.
SELECT PORT
(1-4): 1
The DTE R
ATE
and D
ATA
F
ORMAT
options must be configured
the same on both the local and remote units to function correctly.
For this reason, any change to these options on the local unit
automatically updates the remote unit and these options do not
appear in the configuration menus of the remote unit.