ADTRAN 1200063L1, Manual

Page: 85 / 137

Chapter 7. Configuring DTE Options
61200063L1-20 DSU III TDM User Manual 7-7
Data Set Ready (SR) Options
The SR O
PTIONS
menu is used to select the operating mode for the SR lead.
The factory default setting is O
FF
OOS O
NLY
(Figure 7-6 on page 7-7).
Forced On
The SR control lead remains on regardless of the state of the network.
Off OOS Only
The SR control lead is on except when the DSU III TDM receives an out of
service condition from the network. For more information on OOS see the
section When Out of Service (OOS) on page 9-4.
Off Test Only
The SR lead is on except when the DSU III TDM is executing a test.
Off Test+OOS
The SR lead is on except during a test or when receiving an out of service
condition from the network.
Off Remt Idle
The local SR lead will follow the remote port TR lead.
Figure 7-6. Setting Data Set Ready (SR) Options
1=N ETW O RK O PT.
1=DTE RA TE
2=DA TA FO RM A T
1=LO C A L 3=TX C LO C K
4=C S O PTIO N S
3=C O N FIG 2=DTE O PTIO N S 5=C D O PTIO N S
2=REM O TE
6=SR O PTIO N S 1=FO RC ED O N
3=TEST O PTIO N S 2=O FF O O S O N LY
4=DIA L O PTIO N S 3=O FF TEST O N LY
5=M A N UA L C O M M A N D 4=O FF TEST+O O S
5= O FF REM T ID LE