Installation Instructions
3.0 Hookup Complete
At this stage, the unit should be properly hooked up to the following components:
•
Ethernet network switch or patch panel
•
Power
•
Audio
Once the unit is properly attached to an Ethernet network and power is applied, it will automatically attempt to
download an audio production from the
servers. To do this, your network must supply the following
services:
•
DHCP (Dynamic Host Control Protocol)
. The
unit can use a DHCP server to obtain
an IP address. If you wish to use a static IP address for the
unit, please refer to
section 2.2 of this document.
•
Access to
http://dl.adtel.com
and
http://dl.orbivox.com
. The
unit downloads its
productions from two webservers called
dl.adtel.com
and
dl.orbivox.com
respectively. You must make
sure that the unit can access
both
websites. Please check your firewalls, proxy servers and web traffic
control services to ensure that
both
websites are accessible. (
The dl.orbivox.com site is a back-up link that
normally points to the same IP as dl.adtel.com)
If the unit is able to properly access the
servers, it will begin to download its latest audio production.
This process usually takes approximately 5 or 6 minutes. Please wait at least this long before trying to diagnose any
problems.
After the unit has finished downloading it will begin to play the audio out of the 8
Ω
and 600
Ω
audio ports. If you
have properly attached your telephone system’s Music On Hold audio cable, people will hear the music and
messages when they are placed on hold.
