ADTEL
®
DigADTEL
®
IP
Installation Instructions
For Technical Assistance Please Call 1-800-661-9999
2.0 Hookup
Instructions
These instructions will help you ensure that your
DigADTEL
®
IP
unit is properly connected to all of the necessary
equipment. Please refer to the pictures in the
Package Contents
section to make sure you are connecting the correct
wires.
Please follow these instructions in the order provided. This is important!
1.
Locate the
DigADTEL
®
IP
unit in an area near your telephone system and network
equipment. The unit must be installed in an area within
6 feet
of the telephone
system and
6 feet
within available network equipment. These limits are set be the
length of the enclosed patch cables. If you have access to longer cables, you may
position the
DigADTEL
®
IP
unit at your own discretion.
2.
Connect one end of the supplied CAT5 patch cable to the Ethernet Port of the
DigADTEL
®
IP
unit.
3.
Connect the other end of the patch cable to a network switch or patch panel:
Note:
The port that you use on the Patch Panel or Network Switch must be active!
4.
Plug the power supply block into a live wall outlet or power bar.
5.
Plug the small power, round power connection into the
DigADTEL
®
IP
unit.
6.
Verify that the unit is powered on by checking the LED lights on the front of the unit.
The bottom LED should be green when the unit is on.
7.
Attach the 3.5mm end of audio cable to the 8
Ω
or 600
Ω
AUDIO OUT port on the
DigADTEL
®
IP
unit and punch down the bare wires to a telephone termination
block. Otherwise, use an existing audio cable.
Note:
You may need to use the RCA-to-3.5mm adaptor!
DigADTEL
®
IP
unit
CAT5 Patch Cable
Network Patch Panel
Network Switch
Power Adaptor
RCA-to-3.5mm adaptor
