HCB2001 Capacitive Torch Height
www.machine-controller.com
19
As follow,
2.1. Ensure the Auto Height Control is Enabled, or press the AUTO button and
hold on.
2.2 Turn the Height button clockwise maximum, then the motor will drive loop
move, and turn Height button left and right, the balance position should be found.
Still negative, please try follow ways,
A.lift cutting torch to at least 50mm height, then put it on manual mode.
B. if previous Auto Height too low, then turn the R39 clockwise, the height will
increase. If previous Auto Height too high then turns anti-clockwise, the height
will decrease. DO NOT open control box, and DO NOT damage the R39 during
debug, every time just turn 1/4 round, and record the direction.
C. Press AUTO button and hold on, or turn on the Auto Mode of CNC, adjust the
HEIGHT button of THC, cutting torch shall stop at a position. And the adjusting
arrange changed much.
3. On Auto Mode, turn the HEIGHT button clockwise, the probe shall lift up,
anti-clockwise, it lifts down.
Note: Our THC’s already passed well commissioning. Do not change the
setting unnecessarily, especially the adjustable resistance inside like R39.
Follow are the info of the adjustable resistances.
R39---1K----Auto height setting
R47---20K----Setting the position under circuit-broken protection(HF part) .
Free Offer……………………………
To make users’ job much easier, we designed a Fixture fixing torch and detecting
loop, made of Aluminum Alloy. From May 10th, we offer it with HCB2001 on
Free Base.
