ADS ADSL USB, User Manual

Page: 17 / 20

17
User Manual
3.2 For Other Countries Internet Broadband users
Check with your ADSL Service Provider / System Administrator for the following settings:
ADSL Service Provider
•
The ATM mode
•
For IPoA / RFC 1483 bridged / RFC 1483 routed:
The addresses for
WAN IP ______________________
WAN Subnet Mask ______________________
VPI and VCI values ______________________
Default WAN Gateway ______________________
DNS Relay (Enable/Disable) ______________________
DNS Server (Primary) ______________________
DNS Server (Secondary) ______________________
•
For PPPoA bridged / PPPoA routed / PPPoE:
The PPP Authorization's
VPI and VCI values ______________________
User Name ______________________
Password ______________________
Auto DNS (Enable/Disable) ______________________
•
The Encapsulation method
[not applicable for IPoA] ____________________
System Administrator
•
The addresses for
LAN IP address ______________________
LAN Subnet Mask ______________________
Remote Gateway ______________________
•
To enable or disable NAT
i) Power on your computer. Place the Installation CD onto your CD-ROM Drive.
ii) At the dialog box prompted, click OK . On the MAIN MENU , select RUN DSL WEB
COMMANDER .
iii) Click Configuration > WAN Connections .
You will be prompted for Username and Password . The default for Username and
Password is admin . Click OK .
Click Create a new service . Enter the above settings.
iv) Click Configure , followed by Configuration > Save config to save your settings. Close
your Browser to exit DSL Web Commander.