1
Before you start
●
The analyzer is designed to test 12/24 volt automotive batteries. It can not be used for
other batteries.
●
A freshly charged battery will show a higher voltage than normal voltage; if this is the
case, switch on the headlights for two or three minutes to allow the voltage to stabilize.
●
Always connect directly to the leads of the battery terminals; connection to a remote
post or vehicle ground will affect test result.
●
There are two functions of this tester (there into System Test includes three items):
Battery Test
System Test
Battery Suitability
This Battery Tester is suitable for batteries of the following capacity rating standards and
ranges: (This information is normally found on a sticker on top of the battery.)
CCA
--- 100~1700
IEC
--- 100~1000
EN
--- 100~1700
JIS
--- refer to the conversion table for CCA figures
DIN
--- 100~1000
?
--- If rating standard and range is unknown, please select “
?
”. Testing result will
show SOC (state of charge) and internal resistance but no the SOH (state of health).
Caption for image:
Use
Up
and
Down
keys to scroll
between functions and selections.
(
Up
also used for return to previous
menu and exit program)
Left
key and
Right
key are used for
adjusting number.
Enter
key is used for selection and
confirmation.
Start System Test
Charging System Test
ALT.LOAD Test
