9
Graphs of the flight can be compared with each other. To do
this, read data from altimeter or disk, and then click
"Compare". This brings up a file selection window. Please
select a file with data to compare and click 'Open'. An
additional chart appears on the screen. Speed chart and
comparisons can be switched off in the menu tab "Charts"
9. USB Adapter
As described earlier, to connect the altimeter to a computer you need a special adapter. There
are offered two types of adapters: with charger and without t charger. You can also try to make
cable for connecting the altimeter yourself. To do this in a typical
USB cables cut off one plug (leave the plug connected to a
computer) and isolate the wire length of approximately 1.5 cm.
Then color-coded wires as in the photo should be soldered (or
tightened) to the appropriate connector pins. Please note that the
pin spacing is 2mm. Below are listed the addresses
of shops and types of connectors needed
for the implementation of the cable. Free contact must be filled so
that one could not connect the altimeter in the opposite way.
http://www.tme.eu/pl/katalog/?art=ZL265-5SG#id_category%3D100035%26
zl265-5sg
connector for soldering
http://www.maritex.com.pl/pl/shop/products/ggid/9326
PBMS05S-LF
connector for soldering
BLMS05
Crimp Terminal Housing, 5-pins, single row – clamped connectors
BLMT
Metal terminal, for BLMS and BLMD type housings
10. Charging the battery
Using adapter charger you can recharge rechargeable lithium-polymer (Pol Lid) batteries.
There are available pin connectors where the battery should be connected. Charging is indicated by
LED. When the LED is off charging is finished. As a
source for supplying the charger you can use any
computer, connecting the adapter to the USB connector.
Computers even when switched off supply this voltage.
Now mobile phones have chargers which have the USB
connector. You can use them as power source.
Battery connector
www.tme.pl
NXG-03
plug shield
NXG-T
contact
www.Maritex.com.pl
Crimp Terminal » Crimp with pitch 2.00mm
HS-03
plug shield
HST-LF
contact
CAUTION!! In the connector shield cut off two small blocking tongue
that are placed on both sides, so that the plug is not stuck in the charger-
adapter connector.
Summary of Contents for ALTIMETER ALT-USB
Page 1: ......
