M
icro PC series
Micro PC series
6.5
LED/Alarm Indication:
＊
Green LED, no alarm ------------------------------------------------ City power normal.
＊
Red LED flashing, slow beeping, 2 beeps / 4 sec. ---------- Backup mode.
＊
＊
Red LED flashing, quick beeping, 4 beeps / sec ------------
Red LED flashing, urgent beeping, 8 beeps / sec -----------
Low battery.
Battery Replacement
＊
Red LED flashing, long beep -------------------------------- Over load
＊
Red LED flashing, one beep / 4 sec. ----------------------------
No load (auto shut down
after 30 sec.)
※
If any abnormal condition occurs, and the item 5.3 can not be
executed, you will need to reset your UPS. Please push the button
for at least 10 sec. to shut down the UPS, and to push the button
again to re-start the UPS.
1.
INTRODUCTION
This is a high performance with compact shape stand-by Uninterruptible
Power Supply (UPS) designed to protect your computer from utility line
failure. In the event of utility failure (blackout), the UPS will rapidly
transfer loads to an alternative power source which derives power from
battery set inside the UPS. The backup time for a Pentium III including
15”LCD monitor is about 10 minutes with Micro PC 300, and about 30
minutes with Micro-PC 600.
2.
MAIN
FEATURE
＊
Microprocessor based design.
＊
‘Green power’ design with auto on/off function.
＊
Suitable for 5 1/4” disk size.
＊
Protection for overload & short circuit.
＊
Easy
installation.
3.
CAUTION
＊
The UPS is suitable for personal computer & workstation only; and is
to be installed inside a computer case.
＊
After installation, please make sure that the maximum power
requirement is not over the rated capacity of the UPS. Red LED will
be lighting and alarm will beep if the load is close to the rated value.
Meantime, if the overload is severe, the UPS will shut down
immediately when a blackout happens for protecting UPS itself.
＊
The UPS is shipped from the factory with fully charged internal
batteries; however, the batteries may lose some energy during
delivery and storage. To ensure that the UPS will provide the
expected run-time, the UPS must be charged for at least 12 hours
before your first use. Please simply turn on the UPS after
installation when city power is normal, and the batteries will be
charged automatically.
5 2
