Adomeit Group Veleon, User Manual, Page: 27 / 67

Adjusting Veleon
23
6.7 Adjusting the damper
The hardness can be adjusted via the air pressure in
the damper. The damper can be pumped up to a
pressure of about 15 bar. The hardness of the damper
should be adjusted to the respective load.
To adjust the damper, loosen the bolting lid at first.
After that apply pressure with the optional pump in
the damper (image 6-16).
6.8 Adjusting the tilt lock
The easiest way to adjust the tilt lock is to turn the adjusting screw (1) on the grip shift lever (image 6-
17). This can be necessary when the tilt lock does not limit the tilting as usual. The adjusting should be
done very carefully. If it is not sufficient to adjust the tilt lock with the adjusting screw, the Bowden
cable can be adjusted at the tilt lock wedge itself (image 6-18). It is recommended that this is done
exclusively by a specialist. To adjust the tilt lock this way, the screw (2) has to be loosened. This causes
the cable to loosen too. Now the Bowden cable can be tightened manually, the cable is then secured
by fastening the screw. The cable has to be pressed down by the washer and the screw to prevent
slipping.
The pins on which the wedge runs have to be lubricated regularly! If the wedge does not move
smoothly up or down, or is difficult to release from level 3, this is a sure sign that it is high time to
lubricate the bolts or to have a maintenance done.
image 6-16 : Adjust the damper
vorne
image 6-17: Tilt lock adjusting screw (1) on the grip shift lever
image 6-18: Hexagon screw (2) on the tilt lock
wedge
The pins on which the wedge runs have to be lubricated regularly!
1
2