Adomeit Group Veleon, User Manual, Page: 26 / 67

Adjusting Veleon
22
6.6
Adjusting the cable steering (if available)
To adjust the cable tension and toe angle, loosen the locknuts at first (4). The track adjustment is
done by turning the threaded sleeve (2) (image 6-12).
The adjusting screws (3) left and right regulate the cable tension. To adjust the cable tension first the
locknuts (1) have to be loosened. Thereafter, the adjusting screws (3) must be turned out on both
sides equally until the cable tension is correct. This is correct if the cables are just so without
clearance. If the cable tension and toe angle are set satisfactorily, the locknuts (1) must be tightened
again (image 6-13).
image 6-12: adjust the toe angle
image 6-13: adjust the cable tension
Because of the complexity of the cable steering system, it is highly recommended that only specialist
adjusts it.
4
4 2
3
image 6-14 : Adjusting screw - rear steering cable left
vorne
image 6-15 : Adjusting screw - rear steering cable right
vorne