Rev.
1308
AdMore Lighting Inc. (2017)
LEDV46-T-TS LIGHT KIT
Wiring Instructions
Your AdMore Light Kit has been designed to operate with the tail, brake and turn
signal light functions of your motorcycle or scooter. Using the supplied wire tap
connectors, look as close to the rear taillight as possible to locate the indicated wires:
5-Wire Harness
Your Motorcycle
BLUE*
+ 12V (switched)
RED
Brake Light wire
GREEN
Right Turn Signal wire
YELLOW
Left Turn Signal wire
BLACK
Ground
* Blue wire must be connected to sw12V to operate the embedded mini
controller. On many motorcycles and scooters, the tail light wire may be used for
this purpose. For motorcycles or scooters with a single brake/tail light wire,
connect the Blue wire to a +12V source switched with the ignition. Connect the
Red wire to the single brake/tail light wire.
Mount top case on motorcycle or scooter and attach harness from bike to male
connector on bottom of case. Note: Connector locks by inserting and turning (1/4 turn).
Test functioning of the light kit with your motorcycle’s tail & brake lights & turn signals.
Troubleshooting:
1. Ensure the Blue wire is connected to +12v
2.
Ensure Black wire is connected to a solid ground
3. If lights still do not illuminate, test the power harness by connecting the Blue wire
directly to +12v of a battery and the Black wire to solid ground.
Visit
www.admorelighting.com
for information on
other AdMore products, replacement parts and special offers!
CAUTION: The controller embedded in the main
power harness MUST NOT be submersed in water.
Ensure that the controller is placed in a location that
does not fill with water!
