Rev.
1308
AdMore Lighting Inc. (2017)
LEDV46-T-TS LIGHT KIT
Installation Instructions
Please read these instructions completely before beginning installation!
1.
Lay case on its side. Drill a pilot hole approx. 3” above the top left case hinge (slightly
to the right of the center of the hinge to accommodate an existing or future back rest).
Use the supplied 7/16” drill bit to enlarge hole to the required size*. (Fig. 1)
2.
From inside of case, insert male end of connector and harness through hole and
secure on outside of case using supplied nut. Ensure connector is tight (hand tighten
only). Do not over tighten or the connector may break!
3.
Remove the three (3) screws that hold the upper part of the red lens and the GIVI logo
in place. (Fig. 2)
4.
Remove red lens and top cover together (Fig. 3)
5.
Remove silver insert from center red lens and discard.
6.
Remove the screws holding the side lenses in place and remove the silver inserts from
behind the right and left lenses.
7.
Place LED circuit board behind center red lens. Next, place grommets and then
washers over red shafts. Tighten small screws provided until grommets start to
compress.
8.
Before removing 3M tape from back of LED strips, practice placing the strips on each
of the silver inserts and behind red lenses to determine preferred location.
Recommended location is just over the center ledge of each lens with the edge of
each strip close to the inner portion of the lens. It is important that the wire leads will
reach the center-mounted LED board! Mark the location for each LED strip on the
silver insert, then remove the 3M tape and firmly affix to each silver insert. (Fig. 4)
9.
Drill small hole (minimum 5/16” or 8mm) where indicated and insert small black 3-pin
connector from LED circuit board through drilled hole. (Fig. 5)
10. Connect black connectors from each LED strip to the center-mounted LED board. It is
recommended that a small piece of electrical tape be used on each connector to
ensure that vibration does not dislodge the connector over time. (Fig. 6)
11. Reassemble red lenses with silver inserts and top cover. Replace / tighten all screws.
Wire leads are purposely short to minimize excess wire under the case lid. Note: You
may need a helper to complete this part of the installation.
12. Place provided heat shrink over the connector on the inside harness. Connect both
connectors, slide heat shrink over both connectors and gently heat to secure.
13. Proceed to LEDV46-T-TS LIGHT KIT Wiring Instructions
14. Tidy up installation securing all cables. Use the included cable clamps to secure the
cable to the inside of your case. Be sure to clean surface with an alcohol wipe prior to
affixing the cable clamps to ensure maximum adhesion.
Tools/items required:
Items supplied:
•
Drill with standard drill bits
•
1 -8” V46-T-TS LED circuit board
•
Small Phillips screwdriver
•
2 – 9 pcs LED strips with 2 pin connectors
•
Electrical tape
•
2 wiring harnesses (internal & external)
•
Circuit tester (if available)
•
Extension cable (optional)
•
Connector kit with 5” heat shrink, cable clamps
•
2 rubber grommets, 2 #4 screws, 2 washers
•
These instructions, Warranty card
*
The connector can be placed in any number of places on the case. We recommend, mounting the case on your rack to
determine exactly where you most prefer to install the connector. Should you make a mistake or change your mind in the
future, we can supply complementary plugs to fill a 7/16” drilled hole. Contact us at
www.admorelighting.com
.
