Rev.
AdMore Lighting Inc. (2017)
LED470-KAW-T-TS LIGHT KIT
with
turn signal function
Installation Instructions
Please read all instructions fully BEFORE beginning installation!
1.
Remove the screws that hold the red lenses and cover in place.
2.
Working one side at a time, remove the white insert from behind the red lens.
3.
Align the white LED insert on existing white insert. Punch hole (approx ¼”) in existing
white insert to accommodate black/red wire. (Fig. 1)
4.
Remove two-sided tape and apply white LED insert onto white insert. (Fig. 2)
5.
Using a sharp object, mark the location on the case where the red/black wire exits
from the white insert.
6.
Drill a 5/16” hole, run the red/black wire through the included grommet and into the
newly drilled hole. Seat the grommet in the drilled hole. (Fig. 3)
7.
Pull black/red wire through the grommet and re-align the white insert on case. (Fig. 4)
8.
Repeat steps 2-6 for other side.
9.
Using supplied butt connectors, connect both LED arrays to the case harness as
follows: Right Black to Green, Left Black to Yellow, Both Red wires from LED arrays to
remaining red wire of case harness. (Fig. 5)
10. Lay case on its side. Drill a pilot hole approx. 2”-3” above the top left case hinge
(slightly off center to the left to accommodate an existing or future back rest). Use the
supplied 7/16” drill bit to enlarge hole to the required size*. (Fig. 6)
11. From inside of case, insert male end of connector through hole and secure on outside
of case using supplied plastic nut. Ensure connector is tight (hand tighten only).
Do
not over tighten or the connector may break!
(Fig. 2)
12. Before replacing red lenses using screws removed earlier, proceed to LED470-KAW-
T-TS LIGHT KIT Wiring Instructions to confirm that your light kit is working correctly.
13. Replace red lenses and cover. Secure with the screws removed previously.
14. Tidy up installation securing all cables. Use the included cable clamps to secure the
cable to the inside of your case. Be sure to clean surface with an alcohol wipe prior to
affixing the cable clamps to ensure maximum adhesion.
Tools/items required:
Drill with standard drill bits
Small Phillips screwdriver
Electrical tape
Circuit tester (if available)
Items supplied:
2 – LED470 SMT LED arrays
2 wiring harnesses (internal & external)
Rubber grommets (2), Butt connectors (3), Wire taps (5), Cable Clamps (4)
7/16” drill bit
These instructions
Warranty card
*
The connector can be placed in any number of
places on the case. We recommend, mounting the
case on your rack to determine exactly where you most
prefer to install the connector. Should you make a
mistake or change your mind in the future, we can
supply complementary plugs to fill a 7/16” drilled hole.
Contact us at
www.admorelighting.com
.
