19
SETO-1000
3.5 Powering On the SETO-1000
After power is supplied to the SETO-1000, the following sequence occurs.
1. The PWR LED will light green.
2. The ACT LED will flash red/orange a few times, then stay orange during BIOS bootup.
3. If an OS is installed on either SATA drive or on a bootable USB flash drive connected to the
configuration breakout dongle, the LED will light green after control is passed to the OS.
3.6 Accessing the SETO-1000 Control Console
The SETO-1000 is a headless device and an RS-232 console port is provided via the proprietary
DisplayPort connector on the front panel. User's can connect to the SETO-1000 console from a client
PC using "PuTTY". Download PuTTY from http://www.putty.org.
Connect the breakout cable to the DisplayPort connector as described above in Section 3.2. Run the
program to open the PuTTY configuration window. Set "Serial line" to the COM port of the client PC.
To connect to the SETO-1000 local management console, enter the following settings into the PuTTY
Configuration window:
•
Speed:
115200
•
Parity bit: None
•
Flow Control: None
•
All others settings default
Click "Open" to open the PuTTY command line interface.
