ADLINK Technology NEON-2000-JT2-X Series, User Manual

Page: 20 / 53

10 Connectors and I/O
Leading
EDGE COMPUTING
Table 2-2: DI/O M12 17-Pin Connector Pin Definitions
Table 2-3: DI/O Connector Specifications
12 -- GND
13 Input Digital input 1
14 Input RS-232 RXD (PC>NEON)
15 Output RS-232 TXD (NEON>PC)
16 Input TX2 reset
17 -- GND
NOTE: NOTE:
1. Pin 4 (Digital input 0/Trigger input 0) is programmable. When
configured for trigger input, pin 4 is used for hardware trigger-
ing of the image sensor. Connect an external sensor signal to
pin 4 and set the camera to hardware trigger mode to enable
real-time or hardware-triggered image capture.
2. Pin 5 (Digital output 0/Strobe output 0) is programmable.
When configured for strobe output, pin 5 can be connected to
an LED /strobe controller to adjust the timing latency/delay
according to the camera connected to pin 5.
I/O Category
Maximum
Throughput
Specifications
RS-232 - Baud rate: 9600bps @ 8N1
Digital Input 10 KHz
Common sharing:
1 common for sharing
ground
Input range: 0-5 VDC
High level threshold: 2-5 VDC
Low level threshold: 0-0.8 VDC
Digital Output 10KHz Open-collector
Input voltage
range
3.3-30 VDC
Maximum
sink current
100 mA
Pin Type Description