ADLINK Technology MXE-1300 Series, User Manual, Page: 22 / 80

10 Introduction
1.6.3 Reset Button
The reset button is used to perform hard reset for the MXE-1300.
1.6.4 VGA Connector
The MXE-1300 provides one VGA connector for display on exter-
nal (D-sub 15P) monitor.
1.6.5 DVI-D Connector
The MXE-1300 provides one DVI-D connector for display on an
external (DVI-D) monitor.
1.6.6 USB 2.0 Connectors
The MXE-1300 provides a total of six USB 2.0 ports using Type A
USB connectors, with four ports on the front and two on the rear
panel. All are compatible with Hi-Speed, full-speed, and low-speed
USB devices. All USB ports share one EHCI controller, and two
USB ports share one UHCI controller. The MXE-1300 supports
multiple boot devices, including USB flash drive, USB external
hard drive, USB floppy, USB CD-ROM and etc. The boot priority
and boot device can be configured in BIOS setting.
1.6.7 Compact-Flash Port
The MXE-1300 is equipped with a Type I Compact-Flash socket
on the front panel. The CF interface pr3.3V voltage to the
CF card, is transferred from SATA by an ASIC, and can act as an
alternative storage device for system installation. The MXE-1300
can be booted up via a CF card with OS installed. When the CF
card is used as the boot device, it must be installed before system
NOTE:
NOTE:
The high impedance of long VGA/DVI cables negatively affects
video signal integrity at the receiver side.
It is recommended that VGA/DVI cables be less than 2
meters in length with effective shielding, such as UL
style 2919 AWM. If video transmission distance is to
exceed 10 meters, a VGA/DVI signal repeater or active
KVM may provide better results.
.